GET STARTED

0$

Redirection to the technical assistance portal

MEDISCULPT

Troubleshooting manageable by the client

Field Required to Continue

Next Step

1.1 The device does not turn on.

The touchscreen display does not light up, it remains disactivated.


Make sure the cable is properly plugged into the machine and into the power outlet.

I solved it, thank you
Field Required to Continue

Next Step

3.1 Inside the cooling circuit there are air bubbles that do not allow the liquid to circulate properly.


I solved it, thank you
Field Required to Continue

Next Step

2.1 The touchscreen display appears to be on.

There is no response when typing or selecting commands.


Turn the device off and wait for two minutes. Then turn it back on.

I solved it, thank you
Field Required to Continue

Next Step

3.2 There is not enough liquid inside the cooling circuit.


I solved it, thank you
Field Required to Continue

Next Step

1.2 The device does not turn on.

The touchscreen display does not light up, it remains disactivated.


Make sure the cable is working properly by connecting another electronic device.

I solved it, thank you
Field Required to Continue

Next Step

1.3 The device does not turn on

The touchscreen display does not light up, it remains disactivated.


I solved it, thank you
Field Required to Continue

Next Step

1.4 The device does not turn on

The touchscreen display does not light up, it remains disactivated.


Check the integrity of the fuses with the machine disconnected from the power supply. Open the special compartment located near the power socket. Carefully check that the fuse is not blown or that the wire inside is not broken.

I solved it, thank you
Field Required to Continue

Next Step

2.2 The touchscreen display appears to be on

There is no response when typing or selecting commands.


Make sure there is no external pressure on the display monitor.

I solved it, thank you
Field Required to Continue

Next Step

Flow Alarm

Troubleshooting manageable by the client

Field Required to Continue

Next Step

4.1 The system shows the message "COOLING PHASE WAIT"


Perform Fill and Vent procedure.

I solved it, thank you
Field Required to Continue

Next Step

4.2 Check the temperature


I solved it, thank you
Field Required to Continue

Next Step

4.3 Check that free area around the device


I solved it, thank you
Field Required to Continue

Next Step

5.1 In operating mode, during the treatment phase, one or more applicators do not emit


Verify that the pre-treatment applicator selection has been correctly performed

I solved it, thank you
Field Required to Continue

Next Step

6.1 In operating mode, during the treatment phase, a reduced emission is perceived


Invert the muscle band on which the applicator is positioned. It is necessary to exclude the possibility that the reduced perception is due to a lower sensitivity of the treated area

I solved it, thank you
Field Required to Continue

Next Step

The final estimated price is :

Enter your personal details and you will be redirected to the technical assistance portal, where you can open a ticket and be contacted by a Biotec Italia specialist technician
You will be redirected to your personal account Biotec Italia

Summary

Description Information Quantity Price
Discount :
Total :

SUBMIT